FluentPro Help Center

What do you need help with?

    Sorry, we didn't find any relevant articles for you.

    Send us your queries using the form below and we will get back to you with a solution.


    How to enable form-based authentication in EPM Pulse On-premises

    APPLIES TO: EPM Pulse On-Premises edition with Project Server connection


    When adding the Project Server type of data connection to EPM Pulse, where the form-based authentication is used, it would be needed to enable such authentication in EPM Pulse first. 

    By default, such authentication will be turned off.

    Note: The account with FBA administrator privileges would need to be used as a synchronization account in EPM Pulse.

    1. Open EPMPulse.JobProcessor config file on your server for editing. 

    By default config file is located here:

    C:\Program Files\FluentPro Software\EPM Pulse\Service

    2. Add the following line to the app settings. Save the file when you finish.:

    <appsettings>
     [...]
     <add key="IsFormsAuthForPSConnector" value="true"></add>
     </appsettings>

    3. Open EPM Pulse Web config file on your server for editing and perform the same actions as with EPMPulse.JobProcessor config file before. 

    By default config file is located here:

    C:\Program Files\FluentPro Software\EPM Pulse\Web

    4. Now navigate to the server services and restart EPM Pulse Job processor service

    Was this article helpful?

    Table of contents

      Still can't find what you're looking for?

      Contact Support
      Back To Top